These are the Red and Yellow LED assemblies used to replace the 658 lamps in all PR&E ABX, AMX, BMX & RMX broadcast consoles. This PC board assembly slides into the lamp socket of a series 4 Microswitch.

High Brightness $5.00

This is the new replacement channel on and cue relay assembly. If you have an early BMX-II you should replace the older obsolete assembly. Symtoms are light module taping will cause a left or right channel to drop out.

Replaces 90-156$25.00

The new BMX-II replacement CUE switch assembly is pictured. The kit consists of the bounce free switch, High Brightness LED, Yellow lens cap, special shoulder washer and wire pigtail. The current limiting resistor is part of the pigtail. The LED insert and switch collar tools are shown but sold separately.

Updated CUE switch $20.00

This new adaptor uses the standard BMX-III channel relay. The old style BMX-II relay is obsolete. This new adaptor is used on all BMX-II Control Room monitor modules for Mute functions.

New 90-160 $25.00

Here is our upgrade for BMX-II Line input modules. This PC assembly gets rid of the top switch wiring. It also has the Telco modification. Note the coiled Red wire. This goes to the hidden utility bus in BMX-II frames. A jumper between both switches allows assignment of the left or right for Telco use.

BMX-II Line upgrade $30.00

Here is a photo showing our new Mute Relay adaptors for the BMX-II Control Room monitor module. Is that an Alps pot in place of the monitor pot? Yes it is. These audio taper dual 1K controls make great emergency spares. The price is right too.

Old Rev BMX-II CR $0.00

Pictured are the many cosmetic parts used in the various modules. The large Monitor knob is $7.50, the Mode knob is $6.00 & the Cue knob is $5.00 each. Engraved OFF lens caps are $12.00 each. Fader knobs are $7.50 each. Round wink eye is $3.00, A/B lens cap is $6.00 and the PGM or AUD lens cap is $7.50 each.

Various pricing $12.00